Electrical carburetor heating, Canada | Husqvarna 1151322-95

MAINTENANCE

Electrical carburetor heating

(372XPG)

On models with the designation CARBURETOR HEATING there is an electrically heated carburetor. Electrically powered heating prevents ice formation in the carburetor. A thermostat regulates the heating so that the carburetor always has the right working temperature.

Canada

If this chain saw has the model code XPG/G then it is equipped with an electrically heated carburettor. The electrical heating prevents icing in the carburettor. A thermostat regulates heating so that the carburettor always has the correct working temperature.

Other countries

The carburettor heater is used in the following temperature range: ±0ºC or colder. During high humidity, icing of the carburettor can occur earlier than speciﬁed.

The carburettor heater only heats the carburettor when the 3-way switch is set to position ”II”.

The switch is off in position ”0”, supplies current to the handle heater in position ”I”, supplies current to the carburettor in position ”II”.

CAUTION! The carburettor heater reaches maximum temperature after about 3 minutes. It is therefore important that the machine is not run for longer with the heater switched on. If the switch is left on for too long the carburettor will overheat and lead to running problems or starting problems.

English – 37

Image 37

Husqvarna 1151322-95 manual Electrical carburetor heating, Canada, Other countries

Contents

English 365 372XP Symbols on the machine KEY to SymbolsSymbols in the operator’s manual You will ﬁnd the following labels on your chain saw Contents Dear customer Introduction What is what on the chain saw? What is WHAT? Before using a new chain saw General Safety Precautions Always use common sense Machine′s safety equipmentPersonal protective equipment Chain brake and front hand guard General Safety Precautions Chain catcher Throttle lockoutRight hand guard Vibration damping system Cutting equipment Stop switchMufﬂer General rules Bar Cutting equipment designed to reduce kickbackChain General information on sharpening cutting teeth Sharpening your chain and adjusting depth gauge setting Tensioning the chain Filling with chain oil Lubricating cutting equipmentChecking chain lubrication Needle bearing lubrication Chain drive sprocketChecking wear on cutting equipment Fitting the bar and chain AssemblyWorking with the chain Fuel Fuel Handling Fueling Fuel safetyTransport and storage Long-term storage Starting and stopping Starting and StoppingCold engine Warm engine Stopping Working Techniques Basic safety rulesBefore use General working instructions General rules Terms Basic cutting technique Limbing Tree felling techniqueLog is supported at one end. There is a high risk Safe distance Clearing the trunk and preparing your retreat Felling directionDirectional cuts Felling cut What is kickback? How to avoid kickbackFreeing a tree that has fallen badly Cutting the trunk into logs Carburetor adjustment MaintenanceGeneral High speed jet H Correctly adjusted carburetorChecking brake band wear Checking the front hand guard Immediately Checking the inertia brake release Mufﬂer Changing a broken or worn starter cord StarterTensioning the recoil spring Changing a broken recoil spring Air ﬁlterFitting the starter Must always be replaced When making adjustments Adjustment of the oil pumpSpark plug Lubricating the bar tip sprocket Temperature -5C 23F or colder Air Injection centrifugal cleaningCooling system Winter use Canada Electrical carburetor heatingOther countries Daily maintenance Weekly maintenance Monthly maintenance Maintenance schedule Technical data Technical Data Saw chain ﬁling and ﬁle gauges Your Warranty Rights and Obligations Federal Emission Control Warranty Statement Safety precautions for chain saw American Standard Safety PrecautionsOther safety precautions Kickback safety precautionsPage 1151322-95