KEY to Symbols, Symbols on the machine | Husqvarna 1153183-26

KEY TO SYMBOLS

Symbols on the machine:

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved protective helmet

• Approved hearing protection

• Protective goggles or a visor

This product is in accordance with applicable EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Ignition; choke: Set the choke control in the choke position. This should automatically set the stop switch to the start position.

Adjustment of the oil pump

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

2 – English

Symbols in the operator’s manual:

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

The chain brake must be engaged when the chain saw is started.

WARNING! Kickback may occur when the nose or tip of the guide bar touches an object, and cause a lightning fast reverse reaction, kicking the guide bar up and towards the operator. May cause serious personal injury.

Image 2

Husqvarna 1153183-26 KEY to Symbols, Symbols on the machine, Symbols in the operator’s manual

Contents

3120XP Symbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear Customer What is WHAT? What is what on the chain saw? Always use common sense General Safety PrecautionsBefore using a new chain saw Chain brake and front hand guard Machine′s safety equipmentPersonal protective equipment General Safety Precautions Right hand guard Throttle lockoutChain catcher Vibration damping system Mufﬂer Stop switchCutting equipment General rules Chain Sharpening your chain and adjusting depth gauge settingBar General information on sharpening cutting teeth Too large Increased if the depth gauge setting isAdjustment of depth gauge setting Cause serious or even fatal injury Tensioning the chainLubricating cutting equipment Filling with chain oil Needle bearing lubrication Checking chain lubricationChain drive sprocket Checking wear on cutting equipment Bar Working with the chain AssemblyFitting the bar and chain Fuel Handling Fuel Extra chain oil Fuel safetyFuelling Transport and storage Long-term storage Cold engine Starting and StoppingStarting and stopping Warm engine Stopping Before use Basic safety rulesWorking Techniques General working instructions Working Techniques Limbing Basic cutting techniqueTerms Felling direction Tree felling techniqueSafe distance Directional cuts Clearing the trunk and preparing your retreatFelling cut Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tension Cutting the trunk into logs How to avoid kickbackWhat is kickback? Maintenance Carburettor Correctly adjusted carburettor High speed jet H Checking the brake trigger Changing a broken or worn starter cord MufﬂerStarter Fitting the starter Tensioning the recoil springChanging a broken recoil spring Lubricating the bar tip sprocket Air ﬁlterSpark plug Needle bearing lubrication Adjustment of the oil pumpRunning when making adjustments Cooling system Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenance Technical Data Technical data Bar and chain combinations Saw chain ﬁling and ﬁle gauges EN ISO 12100-22003, Cispr 122005, EN ISO EC-declaration of conformityApplies to Europe only 0404/09/2119Page Page Page Page Original instructions 1153183-26