1-2mm

ASSEMBLY

and the cable position keep 1-2mm play between the cable lug and the slotted fitting when the throttle trigger is fully depressed.

1-2mm

7When the throttle cable is adjusted correctly, tighten the lock-nut (F) and the M3 screw (G).

8Plug the stop switch wires (H) into the matching connectors from the engine. Note that wire polarity is not important.

9Lap and fix the stop switch wires and connectors with clamp (I).

10 Fit the dust cover (J).

11 Refit the air filter cover.

Fitting blades and trimmer heads

WARNING!

! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

English 13

Page 13
Image 13
Husqvarna 143R-II manual Fitting blades and trimmer heads, Assembly, 1-2mm, WARNING! Never use a cutting