START AND STOP
Control before starting
For reasons of safety follow these recommendations!
•Check that the support flange is not cracked due to fatigue
or due to being tightened too much. Replace the support flange if it is cracked.
• Ensure that the nut has not lost its tightening capacity The nut lock shall have a locking torque of at least 1.5Nm. The nut‘s tightening torque shall be
•Check that the blade and the blade guard are not damaged
or cracked. Replace the blade or blade guard if it has been exposed to impact or if it is cracked.
Cold engine
IGNITION:
Set the stop switch to the start position.
CHOKE:
Set the choke control in the choke position.
Warm engine
Use the same starting proce- dure as for the cold engine, but do not set the choke control in the choke position. The start throttle position is obtained by setting the choke control in the choke position and then returning it to its original position.
Stop
The engine is stopped by switching off the ignition.
!WARNING!
When the engine starts with the choke lever in the choke or starter throttle position the cutting tool (blade or trimmer) starts to rotate immediately.
Start and stop
!WARNING!
The complete clutch cover with shaft must be fitted before the machine is started, otherwise the clutch can become loose and cause personal injury.
Always move the machine from the filling position before starting. Place the machine on a flat surface. Make sure the blade cannot come into contact with any object. Make sure that no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 metres.
Start
Press the machine body against the ground using your left hand (NOTE! Do not use your foot). Grip the starter handle with your right hand and slowly pull the starter cord out until you feel some resis- tance, (the starter hooks grip) then pull the cord quickly and powerfully .
Immediately press the choke control in when the engine fires and repeat until the engine starts. When the engine starts, quickly apply full throttle and the start throttle will automati- cally disengage.
NOTE! Do not pull the starter cord out completely and do not release the starter cord from the fully extended position. This can damage the machine.
English – 15 |
