Husqvarna 250 R manual Transport position, handlebar 240R, 240F, 250R, 252RX, Assembly

ASSEMBLY

Transport position, handlebar (240R, 240F, 250R, 252RX)

•The handlebar can easily be turned to fit along the shaft for easier transportation and storage.

•Loosen the knob.Turn the handlebar clockwise so that the throttle handle rests against the engine.

•Now twist the handlebar around the shaft. Tighten the knob.

•Fit the transport guard to the cutting attachment.

Fitting the handlebar (265RX)

•Fit the left handlebar in the handlebar mounting.

•Fit the right handle to the handlebar.

•Adjust roughly and tighten the screws slightly.

•Now make a final adjustment, with the machine hanging from the harness, to obtain the most comfortable working position. Tighten the screws.

•Make the final adjustment to the right handle and lock it in the most comfortable position.

Adjusting the throttle trigger

The throttle trigger can be adjusted to give the best working position. This is done using the Allen screws by the right handle.

Assembling the cutting equipment

WARNING!

!When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

English – 17