MAINTENANCE
265RX
The machine is equipped with fixed L and
When the engine lacks power or accelerates poorly, proceed as follows:
•Check the air filter and replace if necessary.
•When this does not help, contact an authorised service workshop. The needles are available in different sizes.
The
Correctly adjusted carburetor
When the carburetor is correctly adjusted the machine will accelerate without hesitation and burble a little at maximum speed. It is also important that the cutting attachment does not rotate at idle. If the low speed jet L is set too lean it may cause starting difficulties and poor acceleration.
If the high speed jet H is set too lean it will result in less power, less performance, poor acceleration and/or damage to the engine.
If both the L and H jets are set too rich it will results in acceleration problems or too low a working speed.
Muffler
CAUTION! Some mufflers are fitted with a catalytic converter. See chapter on Technical data to see whether your machine is fitted with a catalytic converter.
The muffler is designed to reduce the noise level and to direct the exhaust gases away from the operator. The exhaust gases are hot and can contain sparks, which may cause fire if directed against dry and combustible material. Some mufflers are equipped with a special spark arrestor mesh. If your machine has this type of muffler, you should clean the mesh at least once a week. This is best done with a wire brush. On mufflers without a catalytic converter the mesh should be cleaned weekly, or replaced if necessary. On mufflers fitted with a catalytic converter the mesh should be checked, and if necessary cleaned, monthly. If the mesh is damaged it should be replaced. If the mesh is frequently blocked, this can be a sign that the performance of the
catalytic converter is impaired. Contact your dealer to inspect the muffler. A blocked mesh will cause the machine to overheat and result in damage to the cylinder and piston.
250R/252RX
265RX
CAUTION! Never use a machine with a defective muffler.
WARNING! Mufflers fitted with catalytic
!converters get very hot during use and remain so for some time after stopping. This also applies at idle speed. Contact can result in burns to the skin. Remember the risk of fire!
Cooling system
To keep the working temperature as low as possible the machine is equipped with a cooling system.
The cooling system consists of:
1Air intake on the starter.
2Fins on the flywheel.
3Cooling fins on the cylinder.
4Cylinder cover (directs cold air over the cylinder).
Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the machine overheating which causes damage to the piston and cylinder.
32 – English
