Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna 260 ACX manual Installation and connecting the charging station

Models: 260 ACX

1 72

Download 72 pages 54.36 Kb

Page 19

3. INSTALLATION

Do not position the charging station so that the mower can come closer than 3 metres behind the charging station (for example on a narrow point). The mower will not then find the charging station.

Installation and connecting the charging station

1.Position the charging station in a suitable spot.

2.Secure the charging station to the ground using the supplied nails.

IMPORTANT INFORMATION

It is not permitted to make new holes in the plate. Only the existing holes may be used to secure the plate to the ground.

3.Connect the low voltage cable to the charging station.

Only use original cable and transformer.

4.Connect the low voltage cable to the transformer.

The connectors may be slightly difficult to connect, as they are moisture-proof.

5.Connect the transformer’s power cord to a 230V wall socket. It is preferable to use an earth-fault

breaker as recommended.

18 - English

Image 19

Husqvarna 260 ACX manual Installation and connecting the charging station

Contents

Husqvarna Automower Table of Contents Table of Contents Introduction Introduction SafetySymbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualImportant Information Xxxxxx xxxxx xxxx xxxx xxxxx Use Safety instructionsTransport MaintenancePresentation Numbers in the picture correspond to Automower, what’s what?Capacity Function of AutomowerMowing technique Working method Movement pattern Search method Search method 2 Follow boundary wireSearch method 1 Irregular More than one Automower in a garden Search method 3 Follow guide wireOne Automower in several gardens Carry out the installation in the following steps InstallationPreparations Ideal position of the charging station Installation of the charging stationImportant Information Installation and connecting the charging station Installation of the boundary wire Charging the batteryDo not tread or walk on the charging station plate Best position for the boundary wire Boundaries for the working area Boundaries within the working area Passages when searching for the charging station Passages when mowingSecondary areas Slopes Laying out the boundary wire Joining the boundary wire Laying the boundary wire in towards the charging stationConnecting the boundary wire Installation Linking Automower to the charging station Checking the installationNeed of a guide wire Installation of the guide wirePlacement and connection of the guide wire Maximum 135º Use Charging a discharged batteryStopping Automower Using the timerUse of SMS function Starting AutomowerRestart after more than 20 seconds Switching off AutomowerRestart Restart within 20 secondsAdjusting the cutting height Control panel Shortcuts Select Main switchNumbers Number series Menu functionsMain menu Browse between menusAutomower main menu Installation SettingsTimer CommandsMon Tue Wed Thu Fri Sat Sun Run all Reset all timersYES Start time 1 Stop time 1 Start time 2 Stop time 2End angle 1 InstallationReversing distance Start angle 1When this function is activated Automower will To follow the boundary wire or a guide wire awayGardens where the front and back are joined by a Passage where the charging station cannot beFollow loop DirectionDistance ProportionCorridor width Test Test OUT Settings Time lock PIN codeSMS AlarmDate format Set timeSet date Time formatSound Significance SoundsGarden example Proposed installation and settingsExit angles Exit angles 250 Corridor width Garden Example Battery MaintenanceCharging station ServiceWinter storage AutomowerAfter winter storage CleaningUnderframe and blade disc Wheels Do not use running water when cleaningReplacing the blades ChassisMaintenance Fault messages Trouble shootingTrouble Shooting Fault symptom Environmental Information Technical dataData Automower 260 ACX EU Declaration of Conformity only applies to Europe EU declaration of conformity115 13