3. INSTALLATION
•Low voltage cable (21)
•Nails (24)
•Measurement gauge (25)
•Connector for the loop wire (23)
•Solderless coupler for the loop wire (26)
Contact your dealer for purchase of the following installation material:
•Loop wire for the boundary wire and guide wire (19)
•Staples (22)
During installation you will also need: A hammer to knock the staples into the ground, combination pliers, and a straight spade if the boundary wire is to be buried.
3.2Installation of the charging station
Ideal position of the charging station
For examples of good positioning of the charging station, see 7. Garden example on page 56.
If you are going to install a guide wire, read 3.8 Installation of the guide wire, see page 30, before choosing the position of the charging station.
The charging station must be positioned with a great deal of free area in front of it (at least 3 metres). It should also be positioned centrally in the working area so that Automower® can easily find the charging station and quickly reach all parts of the working area.
It is a good idea to place the charging station in the shadow. The battery is spared if it is charged in the lowest possible ambient temperature.
The charging station must be positioned on relatively level ground. The height difference must not differ more than 5 cm between the front and rear of the charging station.
The charging station must not be positioned so that its plate bends.
16 - English
