3. INSTALLATION
3. Installation
This chapter describes how to install the Husqvarna robotic lawnmower. Before starting the installation read the previous chapter 2. Presentation.
Read also through this entire chapter before beginning the installation. How the installation is done also affects how well the robotic lawnmower works. It is therefore important to plan the installation carefully.
Planning is simplified if you make a sketch of the working area, including all obstacles. This makes it easier to see the ideal positions for the charging station, the boundary wire and the guide wire. Draw on the sketch where the boundary and guide wires should be routed.
In the 7. Garden examples chapter, there are examples of installations.
Visit also www.automower.com for further descriptions and tips regarding installation.
Carry out the installation in the following steps:
3.1Preparations
3.2Installation of the charging station
3.3Charging the battery
3.4Installation of the boundary wire.
3.5Connecting the boundary wire.
3.6Installation of the guide wire
3.7Checking the installation.
3.8First
3.9Test docking with the charging station
The charging station, boundary loop and guide wire must be connected to be able to carry out a complete
3.1 Preparations
1.If the lawn in the working area is longer than 4”
(10 cm), mow it using a standard lawnmower. Then collect the grass.
2. Read carefully through all the steps before the installation.
3.Check that all parts for the installation are
included. The numbers in brackets refer to the component illustration 2.1 What is what?.
• Operator's Manual (24)
•Robotic lawnmower
•Charging station (6)
•Loop wire for boundary loop and guide wire (16)
16 - English
