Husqvarna 305, 308 manual First start-up and calibration, PIN code, Installation

3. INSTALLATION

3.8 First start-up and calibration

Before the robotic lawnmower is operated, a start-up sequence in the robotic lawnmower's menu must be carried out as well as an automatic calibration of the guide signal. The calibration is also a good test to see that the installation of the guide wire has been done in such a way that the robotic lawnmower can easily follow the guide wire from the charging station.

1.Set the main switch to position 1.

2.Open the control panel cover by pressing the STOP button.

A start-up sequence begins when the robotic lawnmower is started for the first time. The following is requested:

•Language

•Time format

•Current time

•Date format

•Date

•Four digit PIN code. All combinations except 0000 are permitted.

IMPORTANT INFORMATION

Use MEMO on page 4 to make a note of the

PIN code.

3.Place the robotic lawnmower in the charging station as requested in the display. The robotic lawnmower will now start the guide calibration, by leaving the charging station and following the guide wire to the point where the guide wire is connected to the boundary loop to begin mowing there. Check that the robotic lawnmower can follow the guide wire all the way.

If it cannot, this may be due to an incorrectly installed guide wire. In this case, check that the installation is performed as described in

3.6Installation of the guide wire on page 29. Therefore, carry out a new Test OUT, see

6.4Installation on page 45.

English - 33