3. INSTALLATION
•Transformer (20)
•Low voltage cable (17)
•Staples (21)
•Connector for connecting the loop wire to the charging station (18)
•Screws for the charging station (19)
•Measurement gauge (22)
•Couplers for the loop wire (23)
During installation you will also need:
•Hammer/plastic mallet (to simplify putting the staples in the ground).
•Combination pliers for cutting the boundary
wire and pressing the contact strips together.
•Edge cutter/straight spade if the boundary wire must be buried. Installation of the charging station.
3.2Installation of the charging station
Ideal position for the charging station
Take the following aspects into consideration when identifying the best location for the charging station:
• Allow for 10 ft (3 m) of free space in front of the charging station.
• It must be possible to lay at least 5 ft (1.5 m) of boundary wire straight out to the right and left of the charging station.
• It must be close to a wall socket The supplied low voltage cable is 33 ft (10 m) long. A 66ft (20 m) low voltage cable is available to purchase as an accessory. Please contact your dealer for more information.
•A level surface to place the charging station on.
•Protection from water spray for instance from irrigation.
•Protection from direct sunlight.
•Place in the lower part of a working area that has a major slope.
For an example of an ideal position of the charging station, see 7. Garden examples on page 52.
English - 17