Husqvarna 2748 GLS (CA) instruction

SERVICE AND ADJUSTMENTS

•Repeat on opposite side of tractor.

•ATTACH REAR LIFT LINKS (C) - Lift rear corner of mower and position slot in link assembly over pin on rear mower bracket (D) and secure with washer and retainer spring.

C

D

FIG. 21

•Repeat on opposite side of tractor.

•Turn steering wheel to position wheels straight for- ward.

•ATTACH FRONT LINK (E) - Work from left side of trac- tor. Insert rod end of link assembly through front hole in tractor front suspension bracket (F) and secure with retainer spring (G) through hole in link located behind the bracket.

•Insert other end of link (E) into hole in front mower bracket

(H) and secure with washer and retainer spring (J).

EH J

F

G

FIG. 22

•Disengage belt tension rod (K) from locking bracket (L).

•Install belt onto engine clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

M

FIG. 23

•Engage belt tension rod (K) on locking bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and engage slowly.

•Raise attachment lift lever to highest position.

•If necessary, adjust gauge wheels before operating mower as shown in the Operation section of this manual.

B M

LF

KA

H E

S

C

D

FIG. 24

20

Image 21

Husqvarna 2748 GLS (CA) manual Engage belt tension rod K on locking bracket L

Contents

GLS CA Page Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope Operation Service III. ChildrenIV. Towing Table of Contents Tools Required for Assembly AssemblyUnassembled Parts To Remove Tractor from Carton Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake System Operation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping To USE Throttle Control D See Fig To Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To Operate Mower Before Starting the Engine Service REMINDER/HOUR MeterReverse Operation System ROS To Operate on Hills To Start Engine See Fig ADD GasolinePurge Transmission Automatic Transmission Warm UP Mowing Tips Maintenance Lubrication ChartGeneral Recommendations Tractor BatteryBrake Operation Tires Engine Engine OIL Filter CleaningMuffler Spark Plugs To Remove Mower See Fig Service and Adjustments First Install ANTI-SWAY BAR S To Install Mower See Figs Engage belt tension rod K on locking bracket L Turn nut right Turn nut left To raise mower To Level Mower Mower Drive Belt Installation To Replace Mower Blade Drive Belt See FigMower Drive Belt Removal To Check Brake To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See Fig Replacing Battery See Fig To Start Engine with a Weak Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse Order To Adjust Throttle Control Cable WireTo Adjust Choke Control To Adjust Carburetor Other StorageFuel System Engine OIL Troubleshooting Points Engine dies when Tractor Model no GLS 96043005000, Product no 43 Schematic Tractor Model no GLS 96043005000, Product no 43 KEY Part Description Electrical Chassis Tractor Model no GLS 96043005000, Product no 43 Drive Tractor Model no GLS 96043005000, Product no 43 Steering Assembly Spark Arrester KIT Engine Seat Assembly Wheels and Tires Decals Mower Deck Tractor Model no GLS 96043005000, Product no 43 Mower Lift Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation 532 41 88-49 Rev 1 03-31-08 SBW/TH Warranty Statement