Service and Adjustments | Husqvarna 2748 GLS (CA) guide

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 17)

•Place attachment clutch in “DISENGAGED” position.

•Lower attachment lift lever to its lowest position.

•Disengage belt tension rod (K) from lock bracket (L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and release slowly.

•Remove mower belt from electric clutch pulley (M).

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link (C) from rear mower bracket (D) - remove retainer springs and washers.

•Go to other side of mower and disconnect the suspen- sion arm and rear lift link.

CAUTION: After rear lift links are dis- connected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

B M

LF

KA

H E

S

C

D

FIG. 17

18

Image 19

Husqvarna 2748 GLS (CA) manual Service and Adjustments, To Remove Mower See Fig

Contents

GLS CA Page II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General Operation III. Children ServiceIV. Towing Table of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled Parts Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts Operation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping To Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See Fig To Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Reverse Operation System ROS Automatic Transmission Warm UP ADD GasolineTo Start Engine See Fig Purge Transmission Mowing Tips Lubrication Chart MaintenanceGeneral Recommendations Tires BatteryTractor Brake Operation Engine Spark Plugs CleaningEngine OIL Filter Muffler To Remove Mower See Fig Service and Adjustments First Install ANTI-SWAY BAR S To Install Mower See Figs Engage belt tension rod K on locking bracket L Turn nut right Turn nut left To raise mower To Level Mower To Replace Mower Blade Drive Belt See Fig Mower Drive Belt InstallationMower Drive Belt Removal To Remove Wheel for Repairs See Fig To Replace Motion Drive Belt See FigTo Check Brake Front Wheel TOE-IN/CAMBER To Remove CABLES, Reverse Order To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Attach Jumper Cables To Adjust Carburetor WireTo Adjust Throttle Control Cable To Adjust Choke Control Engine OIL StorageOther Fuel System Troubleshooting Points Engine dies when Tractor Model no GLS 96043005000, Product no 43 Schematic Tractor Model no GLS 96043005000, Product no 43 KEY Part Description Electrical Chassis Tractor Model no GLS 96043005000, Product no 43 Drive Tractor Model no GLS 96043005000, Product no 43 Steering Assembly Spark Arrester KIT Engine Seat Assembly Wheels and Tires Decals Mower Deck Tractor Model no GLS 96043005000, Product no 43 Mower Lift Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation 532 41 88-49 Rev 1 03-31-08 SBW/TH Warranty Statement