Husqvarna 320 AWD, 318 manual Driving the Rider, Connecting the jump leads, Important Information

Driving

Connecting the jump leads

•Connect each end of the red cable to the POSITIVE pole

(+) on each battery, exercise care not to short circuit any of the ends against the chassis.

•Connect one end of the black cable to the NEGATIVE pole (-) on the fully charged battery.

•Connect the other end of the black cable to a good CHASSIS EARTH, away from the fuel tank and the battery.

Remove the cables in the reverse order

•The BLACK cable is removed from the chassis and then the fully charged battery.

•Finally the RED cable from both batteries.

Driving the Rider

1Release the parking brake by first pressing down the parking brake pedal and then releasing it.

2Carefully press down one of the pedals until the required speed is obtained. Pedal (1) is used to drive forwards, and pedal (2) to drive backwards.

1

2

3Select the required cutting height (1-10) with the cutting height lever.

It is important that the air pressure in both front wheels is equal, 60 kPa / 0,6 bar / 8.5 PSI, to produce an even cutting height.

4Press in the lock button on the lifting lever and lower the cutting unit.

IMPORTANT INFORMATION

The life span of the drive belts is increased significantly if the engine runs at a low speed when the blades are engaged. Therefore apply full throttle first when the cutting unit has been moved to the mowing position.

English – 15