SAFETY INSTRUCTIONS
•See instructions under the heading Start. Start the machine and apply full throttle. Release the throttle and check that the cutting attachment stops and remains at a standstill. If the cutting attachment rotates with the throttle in the idle position then the carburettor idle setting must be checked. See instructions under the heading Maintenance.
Stop switch
•Start the engine and make sure the engine stops when you move the stop switch to the stop setting.
Vibration damping system
•Regularly check the vibration damping units for cracks or deformation.
•Check that the vibration damping element is undamaged and securely attached.
Muffler
•Never use a machine that has a faulty muffler.
•Regularly check that the muffler is securely attached to the machine.
•If the muffler on your machine is fitted with a spark arrestor mesh this must be cleaned regularly. A blocked mesh will cause the engine to overheat and may lead to serious damage.
Never use a muffler with a defective spark arrestor mesh.
Cutting equipment
This section describes how you can achieve maximum clearing capacity and extend the life of the cutting attachment through correct maintenance and using the right type of cutting attachment.
Check the cutting equipment with regard to damage and crack formation. Damaged cutting equipment should always be replaced.
•Only use cutting equipment recommended by us!
•Keep the chain’s cutting teeth properly sharpened! Follow our instructions and use the recommended file gauge. A damaged or badly sharpened chain increases the risk of accidents.
•Maintain the correct raker clearance! Follow our instructions and use the recommended raker gauge. Too large a clearance increases the risk of kickback.
•Keep the chain properly tensioned! If the chain is slack it is more likely to jump off and lead to increased wear on the bar, chain and drive sprocket.
6 – English
