MAINTENANCE
Lubricating the flexible drive shaft (326Ex)
Inside the hollow drive shaft of the edger is a flexible drive shaft. This flexible drive shaft should be regularly lubricated every 25 hours in operation. Loosen the two screws on the angle gear and remove it. The flexible drive shaft is easily removed from the hollow shaft by taking a firm grip on the shaft end. Lubricate the entire length of the flexible drive shaft and reinsert it in the hollow drive shaft. Turn the shaft while inserting it so that it correctly engages in the clutch. Refit the angle gear on the hollow drive shaft and tighten the two screws.
Adjusting the edger’s cutting depth (326Ex)
The cutting depth must be adjusted before starting work.
•Loosen the locking knob (A) and rotate the guard by moving the locking knob forwards or backwards. If the locking knob is moved forwards (away from the machine) the cutting depth is increased. If the locking knob is moved backwards (towards the machine) the cutting depth is reduced.
A
•Set the desired cutting depth.
•Lock the locking knob.
Adjusting the edger’s cutting depth (326ES)
The cutting depth must be adjusted before starting work.
•Loosen the wing nut.
•Set the desired cutting depth.
•Tighten the wing nut.
CAUTION! Use only HUSQVARNA replacement parts. Use of other brands of replacement parts can cause damage to your unit or injury to the operator or others. Your warranty does not cover damage or liability caused by the use of accessories and/or attachments not specifically recommended by HUSQVARNA.
English – 25 |
