ASSEMBLY
Assembling the cutting equipment
WARNING!
! When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.
WARNING! Under no circumstances may
! the edge cutter blade be used without the blade guard fitted.
Assembling the blade (326Ex)
Fit the blade as follows:
1Fit the drive disc (A) on the outgoing shaft. Make sure that the edge that fits in the hole of the blade is facing outward.
2Block the blade rotation by inserting the locking pin in the hole behind the blade guard engaging it in the corresponding hole in the drive disc.
3Fit the blade (B) on the drive disc.
4Fit the support flange (C). The support flange must be fitted with its outer edge hard up against the blade.
5Fit the locking nut (D). CAUTION! The locking nut has a
6 Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before using the machine.
Assembling the blade (326ES)
Fit the blade as follows:
A
B
C
D
E
1Fit the drive disc (A) on the outgoing shaft. Make sure that the edge that fits in the hole of the blade is facing outward.
2Block the blade rotation by inserting the locking pin in the hole behind the blade guard engaging it in the corresponding hole in the drive disc.
3Fit the blade (B) on the drive disc.
4Fit the support flange (C). The support flange must be fitted with its outer edge hard up against the blade.
5Fit the two washers (D) and the locking screw (E).
6Tighten the locking screw to a torque of
7 Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before using the machine.
English – 13 |
