ASSEMBLY
Fitting the loop handle
•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
•Fit the bolt, securing plate and wing nut as shown in the diagram.
•Tighten the wing nut.
Assembling the angle gear (326Ex)
•Assemble the angle gear back on the suppporting tube. Turn the blade so that the drive shaft engages in the angle gear.
•Position the angle gear so that its slot is aligned with the line on the supporting tube.
•Firmly tighten the screw.
Assembling the angle gear (326ES)
•Assemble the angle gear back on the suppporting tube. Turn the blade so that the drive shaft engages in the angle gear.
•Tighten the two screws.
12 – English |
