Husqvarna 326EX manual Fuel Handling, Fuel mixture, Fuelling

FUEL HANDLING

Fuel mixture

NOTE!

The edger is fitted with two-stroke engines and must always be run on a mixture of gasoline and two-stroke oil. To ensure the correct mixture proportions it is important to measure the quantity of oil accurately. When mixing small amounts of fuel small discrepancies in the amount of oil has a great bearing on the proportions of the fuel mixture.

!WARNING!

Always provide good ventilation when han- dling fuel.

Gasoline

NOTE!

Always use high grade unleaded oil mixed gasoline (minimum 87 RON). Leaded fuel will destroy the catalytic converter and it will no longer serve its purpose.

• This engine is certified to operate on unleaded gasoline.

•The lowest recommended octane rating is 87. If you run the engine on lower octane rating than 87 so-called

“knocking“can occur. This leads to an increased engine temperature, which can result in a serious engine breakdown.

•When working at continuous high revs a higher octane rating is recommended.

Two-stroke oil

• For the best results use HUSQVARNA two-stroke oil, which has been specially developed for two-stroke engines.

Mixing ratio 1:50 (2%).

• Never use two-stroke oil intended for water cooled outboard motors, so-called outboard motor oil.

•Never use oil intended of four-stroke engines.

Mixture

•Always mix gasoline and oil in a clean container intended for fuel.

•Always start by filling half the quantity of gasoline required. Then add the entire oil quantity. Mix (shake) the fuel mixture. Fill the remaining quantity of gasoline.

•Mix (shake) the fuel mixture carefully before filling in the machine‘s fuel tank.

•Do not mix more than max. one month’s supply of fuel.

•If the clearing saw is not used for a long period of time, the fuel tank should be emptied and cleaned.

•This engine is certified to operate on unleaded gasoline.

!WARNING!

The catalytic converter muffler gets very hot during and after use. This also applies during idling. Be aware of the fire hazard, especially when handling the saw near flammable substances or vapours.

Fuelling
	WARNING!
	The following precautions reduce the risk of
! fire:
	Do not smoke or place any sources of heat in
	the vicinity of the fuel. Never refuel when the
	engine is running. Always stop the engine and
	let it cool for a few minutes before refuelling.
	Open the fuel cap slowly when fuelling so that
	any over pressure is released slowly. Tighten
	the fuel cap carefully after refuelling. Always
	move the machine from the fuelling place
	before starting.
• Clean around the fuel
cap. Contamination in the
tank can disrupt
operations.
• Ensure that the fuel is
well mixed by shaking the
container before filling the
tank.
Gasoline	Oil
	2%(1:50)
Lit.	Lit.
5	0,10
10	0,20
15	0,30
20	0,40
US	US
gallon	fl. oz.
1	2 1/2
2 1/2	6 1/2
5	12 7/8
	English – 14