ASSEMBLY

Assembling the cutting equipment

• Hook the blade guard/combination guard (A) onto the

fitting on the shaft and secure with the bolt.

!

WARNING!

When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting

CAUTION! Use the recommended blade guard. See

the Technical data section.

• Fit the drive disc (B) on the output shaft.

• Turn the blade shaft until one of the holes in the drive

disc aligns with the corresponding hole in the gear

housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Place the blade (D), support cup (E) and support

flange (F) on the output shaft.

• Fit the nut (G). The nut must be tightened to a torque

of 35-50 Nm (3.5-5 kpm). Use the socket spanner in

the tool kit. Hold the shaft of the spanner as close to

the blade guard as possible. To tighten the nut, turn

the spanner in the opposite direction to the direction

of rotation (Caution! left-hand thread).

! attachment without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting a blade guard, grass blade and grass cutter

G

F

E

D

A B

C

Fitting the blade guard and saw blade

K

J

H

LI

A

Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.

English 15

Page 15
Image 15
Husqvarna 327RD manual Assembling the cutting equipment, Fit the nut G. The nut must be tightened to a torque