Adjusting the harness and brush cutter | Husqvarna 327RD specification

ASSEMBLY

Adjusting the harness and brush cutter

WARNING! When using a brush cutter it

! must always be hooked securely to the harness. Otherwise you will be unable to control the brush cutter safely and this can result in injury to yourself or others. Never use a harness with a defective quick release.

Standard harness

Quick release

At the front is an easily accessible, quick release. Use this if the engine catches ﬁre or in any other emergency situation that requires you to free yourself from the machine and harness.

Spreading the load on your shoulders

A well-adjusted harness and machine makes work much easier. Adjust the harness for the best working position. Tension the side straps so that the weight is evenly distributed across both shoulders.

Correct height

Adjust the shoulder strap so that the cutting attachment is parallel to the ground.

Correct balance

Let the cutting attachment rest lightly on the ground. If you use a saw blade it should balance about 10 cm above the ground to prevent contact with stones and the like. Adjust the position of the suspension ring to balance the brush cutter correctly.

English – 17

Image 17

Husqvarna 327RD manual Adjusting the harness and brush cutter, Standard harness, Spreading the load on your shoulders

Contents

323RII 327RX-series Symbols KEY to Symbols Contents Dear customer Introduction What is what on the brush cutter? What is WHAT? Personal protective equipment General Safety Precautions Throttle lockout Machine′s safety equipment Vibration damping system Stop switchCutting attachment guard Mufﬂer Quick release Cutting equipment Cutting equipmentLocking nut General rules Sharpening grass cutters and grass bladesSharpening the saw blade Trimmer head Fitting the handlebar 327Rx, 327RDx AssemblyFitting the handlebar 323RII Dismantling AssemblyAssembling and dismantling the two-piece shaft 327RDx Fit the nut G. The nut must be tightened to a torque Assembling the cutting equipment Fitting other guards and cutting attachments Standard harness Adjusting the harness and brush cutterSpreading the load on your shoulders Correct height Fuel Fuel safetyFuel Handling Mixing Fueling Check before starting Starting and StoppingStarting and stopping Starting Starter cord around your hand For throttle handles with a start throttle lockStopping Working Techniques Basic safety rulesGeneral working instructions ABC of clearing Forestry clearing using a saw blade Brush cutting with a saw blade Grass trimming with a trimmer head Grass clearing using a grass blade Carburetor Maintenance Remember the risk of ﬁre MufﬂerCooling system Bevel gear Cleaning the air ﬁlterAir ﬁlter Two-piece shaft 327RDx Spark plug Maintenance Daily Weekly Monthly Maintenance schedule Technical data Technical Data Approved accessories Type Cutting attachment guard, Art. no Your Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Page Original instructions 1153290-95