Husqvarna 340, 345, 346XP,350, 351, 353 manual Stop switch - refitting, Choke control - removal

Repair instructions

Stop switch – refitting

1

Carefully press the new stop switch into place. Check that the switch’s upper mounting clips over the air filter holder.

2

Refit the stop plate. Engage the stop plate in the front slot first then lift the rear edge onto the stop switch. Slide the stop plate in as far as it will go.

3

Refit:

•the leads to the stop plate and stop switch

•air filter

•cylinder

Choke control – removal

1

Remove the cylinder cover, air filter and stop switch. Disconnect the fuel hose from the carburet- tor.

NOTE!

Do not use knurled pliers to disconnect or reconnect the fuel hose. This could damage the hose and lead to leakage or fracture.

A

2

C

B

Disconnect the pushrod from the carburettor by first carefully prising up the spring over the end of the rod, where it connects to the throttle lever (A). Then press the throttle lever forwards (B) while pressing the throttle pushrod backwards (C) and lifting it off the lever. Withdraw the throttle pushrod from the tank and lift it upwards without pulling it through the rubber inlet manifold. Carefully release the carbu- rettor assembly from the right-hand rubber mount- ing and lift it upwards.

3

Compress the clip that holds the choke control to the carburettor while pulling it out at the same time. Disconnect the choke control from the air filter holder.

16 – English