Husqvarna 395XP, 395XPG Starter housing

MAINTENANCE

English – 35

Starter housing

Changing a broken or worn starter cord

• Loosen the screws that hold the starter against the

crankcase and remove the starter.

• Pull out the cord approx. 30 cm and hook it into the

notch in the rim of the pulley. Release the recoil spring

by letting the pulley rotate slowly backwards.

• Undo the screw in the centre of the pulley and remove

the pulley. Insert and fasten a new starter cord to the

pulley. Wind approx. 3 turns of the starter cord onto

the pulley. Connect the pulley to the recoil spring so

that the end of the spring engages in the pulley. Fit the

screw in the centre of the pulley. Insert the starter cord

through the hole in the starter housing and the starter

handle. Make a secure knot in the end of the starter

cord.

Tensioning the recoil spring

• Hook the starter cord in the notch in the pulley and

turn the starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned at least a

further 1/2 turn when the starter cord is pulled all the

way out.

Changing a broken recoil spring

• Lift up the starter pulley. See instructions under the

heading Changing a broken or worn starter cord.

Remember that the recoil spring is coiled under

tension in the starter housing.

• Remove the cassette with the recoil spring from the

starter.

• Lubricate the recoil spring with light oil. Fit the

cassette with recoil spring in the starter. Fit the starter

pulley and tension the recoil spring.

!

WARNING! When the recoil spring is

wound up in the starter housing it is

under tension and can, if handled

carelessly, pop out and cause personal

injury.

Care must be exercised when replacing

the return spring or the starter cord.

Wear protective glasses and protective

gloves.

Contents

Main 395XP 395XPG KEY T O SYMBOLS Symbols on the mac hine: CONTENTS Contents INTR ODUCTION Dear Customer , WHA T IS WHA T? Bef ore using a new chain saw Impor tant Al ways use common sense ont hand guard Chain brake and fr s safety equipment Page Will my hand always activate the chain brake during a kickback? Will my inertia activated chain brake always activate during kickback in the event of a kickback? Will my chain brake always protect me from injury in the event of a kickback? Throttle trigger lockout Chain catcher Cutting equipment General rules Cutting equipment designed to reduce kickback Sharpening your chain and adjusting depth gauge setting Tensioning the chain Lubricating cutting equipment Page ASSEMBLY Fitting the bar and chain Fitting a spiked bumper FUEL HANDLING Fuel Petrol Two-stroke oil Mixing FUEL HANDLING Fueling Fuel safety Transport and storage Long-term storage STARTING AND STOPPING Starting and stopping A Cold engine Warm engine STARTING AND STOPPING Stopping Before use: General working instructions Basic safety rules , General rules Basic cutting technique Tree felling technique Page Page Freeing a tree that has fallen badly How to avoid kickback What is kickback? Carburettor adjustment Carburettor with movement limiters Function, Basic settings, Fine adjustment Function Basic settings and running in Fine adjustment Carburettor without movement limiters H L Function L Basic settings and running in Fine adjustment Conditions Low speed jet L H Correctly adjusted carburettor Checking, maintaining and servicing chain saw safety equipment Chain brake and front hand guard Throttle trigger lockout Chain catcher Right hand guard Vibration damping system Stop switch Mufer Starter housing Changing a broken or worn starter cord Tensioning the recoil spring Changing a broken recoil spring Fitting the starter Air lter Spark plug Lubricating the bar tip sprocket Needle bearing lubrication Adjustment of the oil pump Cooling system Air Injection centrifugal cleaning Winter use Temperature -5 Fitting the winterising kit Temperature 0 C or colder Maintenance schedule Technical data Guide bar and saw chain combinations Saw chain ling and le gauges EC Declaration of Conformity (Applies to Europe only)