KEY TO SYMBOLS
Symbols on the machine:
WARNING! Chain saws can be dangerous! Careless or improper use can result in serious or fatal injury to the operator or others.
Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.
Always wear:
•Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator′s hands must be used to operate the chain saw.
Never operate a chain saw holding it with one hand only.
Contact of the guide bar tip with any object must be avoided.
Tip contact may cause the guide bar to move suddenly upward and backward
Other symbols/decals on the machine refer to special certification requirements for certain markets.
Symbols in the operator’s manual:
Switch off the engine before
carrying out any checks or maintenance. CAUTION! The start/
stop switch automatically returns to
run position. In order to prevent unintentional starting, the spark
plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
2 – English
Visual check.
Protective goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake must be engaged when the chain saw is started.
You will find the following labels on your chain saw:
EPA II
The Emissions Compliance Period referred to on the Emission Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emissions requirements. Category C = 50 hours, B = 125 hours, and A = 300 hours.
Maintenance, replacement, or repair of the emission control devices and system may be performed by any nonroad engine repair establishment or individual.
The engine exhaust from this product contains chemical known to the State of California to cause cancer, birth defects or other reproductive harm.
115 10
