What is WHAT?, What is what on the chain saw?

WHAT IS WHAT?

What is what on the chain saw?

1	Cylinder cover	17	Mufﬂer
2	Decompression valve	18	Chain
3	Air purge	19	Bar tip sprocket
4	Start reminder	20	Bar
5	Combined start and stop switch	21	Bumper spike
6	Rear handle	22	Chain catcher
7	Information and warning decal	23	Chain tensioning screw
8	Fuel tank	24	Clutch cover
9	Adjuster screws carburetor	25	Right hand guard
10	Starter handle	26	Throttle control
11	Starter	27	Throttle lockout
12	Chain oil tank	28	Chain tensioner wheel (445e, 450e)
13	Product and serial number plate	29	Knob (445e, 450e)
14	Felling direction mark	30	Operator’s manual (EPA)
15	Front handle	31	Bar guard
16	Front hand guard	32	Combination spanner

115 10 81-95 Rev.1 2008-01-08

English – 5

Page 5

Image 5

Husqvarna 440e, 435e manual What is WHAT?, What is what on the chain saw?

Contents

445 445e 450e Symbols on the machine KEY to SymbolsSymbols in the operator’s manual You will ﬁnd the following labels on your chain saw Contents Dear customer Introduction What is what on the chain saw? What is WHAT? Before using a new chain saw General Safety Precautions Always use common sense Machine′s safety equipmentPersonal protective equipment Chain brake and front hand guard General Safety Precautions Chain catcher Throttle lockout Right hand guard Stop switchVibration damping system Mufﬂer General rules Cutting equipmentCutting equipment designed to reduce kickback Bar General information on sharpening cutting teeth Sharpening your chain and adjusting depth gauge setting Increased if the depth gauge setting is General advice on adjusting depth gauge settingAdjustment of depth gauge setting Too large Bar and cause serious or even fatal injury Tensioning the chain445 445e, 450e Checking chain lubrication Lubricating cutting equipmentFilling with chain oil Checking wear on cutting equipment Chain drive sprocketNeedle bearing lubrication Fitting the bar and chain Assembly445 445e, 450e 115 10 81-95 Rev.1 Fuel Fuel Handling Fueling Fuel safetyTransport and storage Long-term storage Starting Starting and StoppingStarting and stopping Stopping Working Techniques Basic safety rulesBefore use General working instructions General rules Terms Basic cutting technique Limbing Tree felling techniqueLog is supported at one end. There is a high risk Safe distance Directional cuts Felling directionClearing the trunk and preparing your retreat Felling cut Freeing a tree that has fallen badly How to avoid kickbackWhat is kickback? Cutting the trunk into logs General MaintenanceCarburetor adjustment Checking the inertia brake release Mufﬂer Tensioning the recoil spring StarterReplacing the starter cord Replacing the return and drive springs Air ﬁlterFitting the starter Recoil spring a Lubricating the bar tip sprocket Spark plugNeedle bearing lubrication Cooling system Winter use Air Injection centrifugal cleaningTemperature -5C 23F or colder Daily maintenance Weekly maintenance Monthly maintenance Maintenance schedule Technical data Technical Data Saw chain ﬁling and ﬁle gauges Bar and chain combinations050/1,3 mm 058/1,5 mm Your Warranty Rights and Obligations Federal Emission Control Warranty Statement Safety precautions for chain saw American Standard Safety PrecautionsOther safety precautions Kickback safety precautionsPage 1151081-95