![](/images/new-backgrounds/1260908/26090811x1.webp)
EXCEL SERIES BLADES
The Excel Series of diamond blades have been designed specifically for the
Purple Excel Series 1000 | Ultra hard aggregate and non abrasive sand | |
Green Excel Series 2000 | Hard to ultra hard aggregate and non abrasive sand | |
Red Excel Series 3000 | Hard aggregate, medium abrasive sand | |
Orange Excel Series 4000 | Medium hard aggregate, medium abrasive sand | |
Yellow Excel Series 5000 | Medium hard to soft aggregate, abrasive sand | |
Black Excel Series 6000 | Soft aggregate, highly abrasive sand |
BLADE AND SKID PLATE INSTALLATION
Step 1
With the saw turned off, unfold the handle to its full upright position and tighten the locking knob. With both hands, push down on the handle bar and raise the to its full height and locked position.
Step 2
Remove the blade block cover (A) by turning the two locking knobs
Step 3
Remove the blade shaft bolt by continuing to turn the bolt
(E).
WARNING
Inspect the blade (K) for any damage. Do not use any blade that has cracks, nicks, flaws or a damaged arbor. Make sure the blade is marked with a maximum operat- ing speed greater than 3200 rpm.
Step 4
Match the blade
Step 5
Install a new skid plate (G) by hooking the front on the front blade block shaft pin. Connect the rear blade block shaft and the rear of the skid plate by installing the locking pin (H).
Step 6
Install the blade cover by turning the two knobs and tighten un- til fully seated against the blade block. Lift the front and rear of the skid plate to insure the blade slides through the skid plate freely.
Step 7
Insure the lexan shields (I & J) move freely up and down. When replacing a worn blade, thoroughly clean the concrete from blade block and blade cover before installing the new blade. Discard the old skid plate and replace it with a new skid plate.
NOTE:
The patented skid plate is the most important part of the
A K
E
D
H F
BC J
I
G
6