HOW to Replace the Auger

MAINTENANCE

1.Remove the belt cover. See “How To Remove The Belt Cover”.

2.Remove the drive belt. See “How To Replace The Drive Belt”.

3.Use a 1-inch wrench and remove the auger pulley from the auger shaft (threads are left hand; turn clock- wise to remove). (See Figure 22).

4.To keep the auger from rotating, set a 2”x4” piece of wood on the center paddle to secure auger.

5.Use a 7/16-inch wrench and remove the fasteners from the bearing assembly. Remove the bearing assem- bly from the auger housing.

6.Slide the auger out of the bearing assembly on the right side of the snow thrower.

7.Tip the auger enough to allow the auger to slide out of the auger housing.

8.To install auger, reverse the above steps.

Wood

Auger Housing

Center Paddle

Auger

Bearing Assemlby

Auger Pulley

Figure 22

1740274

Page 24

Image 24

Husqvarna 521SSE, 521SSR manual HOW to Replace the Auger

Contents

Operator’s Manual 1740274 Introduction For Your Records Operating Symbols and their meanings Rules for Safe Operation Training Children Table of Contents Safety Decals Identifying Your Snowthrower OWNER’S Information Warranty Statement Limited WarrantyHUSQVARNA’S Obligations Under the Warranty Items not Covered by this Warranty Procedure to Obtain Warranty ConsiderationExceptions and Limitations Customer Responsibilities Assembly Parts Bags ContentsTools Required for Assembly HOW to Remove the Snow Thrower from the Carton HOW to Assemble the Handle HOW to Install the Chute Checklist Operation Know Your SnowthrowerEngine and Snow Thrower Operating Controls HOW to Stop the Snowthrower HOW to Control Snow DischargeHOW to Throw Snow HOW to Move Forward HOW to MIX the Fuel Mixture Fuel Mixture Chart mixtureBefore Starting the Engine HOW to Stop the Engine HOW to Start the EngineHOW to Start a Cold Engine Switch box HOW to Clear a Clogged Discharge Chute Snow Throwing TipsDRY and Average Snow WET Packed Snow Service Recommendations Service RecommendationsAfter Each USE Lubrication HOW to Lubricate the Idler ARM Maintenance HOW to Adjust the Belt TensionHOW to Replace the Auger Belt HOW to Replace the Scraper Blade HOW to Free the Auger Cable HOW to Adjust the Chute Crank HOW to Adjust the Auger Control CableIt cannot make contact with the spark plug HOW to Replace the Drive Belt HOW to Replace the Auger To Adjust the Carburetor To Adjust or Replace the Spark PlugThis Spark Ignition System Complies with Canadian ICES-002 Storage OFF Season StorageRemoving the Snowthrower from Storage Trouble Shooting Chart Problem Look for Remedy