ASSEMBLY
PARTS BAGS CONTENTS:
1 − 2.6 ounces 2−cycle oil
1 − Owner’s Manual
TOOLS REQUIRED FOR ASSEMBLY
1 − Knife
1 − Pliers
2 − Adjustable Wrenches
1 − Flat Screwdriver
WARNING: Always wear safety glasses or eye shields while assembling the snowthrower.
Figure 6 shows the snow thrower in the operating position.
References to the right or left hand side of the snow thrower are from the viewpoint of the operator’s position behind the unit.
HOW TO REMOVE THE SNOW THROWER FROM THE CARTON
1.Locate all parts that are packed separately and remove from the carton.
2.Remove and discard the packing material from around the snow thrower.
3.Cut down all four corners of the carton and lay the side panels flat.
4.Cut off the plastic bag that covers the snowthrower.
5.Hold onto the lower handle and pull the snow thrower off the carton.
CAUTION: DO NOT back over cables.
6. Remove the packing material from the handle assembly.
HOW TO INSTALL THE CHUTE CRANK
1.Remove the screw and nut from the shaft with flat screw- driver and adjustable wrench (see Figure 2).
2.Put the chute crank rod through the bracket on the lower handlebar. (See Figure 3)
3.Install the chute crank rod onto the shaft.
4.Fasten the chute crank rod with the screw and nut that were removed in step 1.
1740274 | 10 |
| Chute Crank |
| Rod |
| Nut |
Screw | Shaft |
| Figure 2 |
