FREQUENTLY ASKED QUESTIONS
How do I start my pressure washer?
1.Make sure you have gas and oil in the engine.
2.Turn the water on, then squeeze the trigger on the gun to make sure the water will flow smoothly out of the nozzle or tip.
3.Put the engine throttle control in the “Fast/Start” position. Set the fuel valve to “ON” Set the On/Off switch to “ON” (if applicable).
4.Close the choke.
5.Squeeze and hold the trigger (to relieve any back pressure in the pump) while pulling the starter cord.
6.If the engine does not start after three tries, see Troubleshooting Section (Pages
What type of oil do I use?
ENGINE
THE ENGINE DOES NOT COME FILLED WITH OIL. For engine oil types and quantities refer to Pages 16 and 19 of this manual and also refer to the included engine owner’s manual for oil changing instructions.
PUMP
See Page 17 for pump oil types and quantities. Please note the 5525PW model has a pump that is sealed and does not require service.
Why don’t I have any water pressure?
•Is the water hose attached to the pressure washer?
•Is the water turned on?
•Check for any kinks, leaks, or blockage in the hoses, fittings, or the nozzle.
•Is the inlet filter screen free of debris? Check and remove debris if needed.
•Is the quick connect tip in place? (See Page 9.)
How do I get high pressure?
•Use any color tip except black. The black tip is only used for low pressure detergent application.
How do I get the soap suction to work?
For Detergent Tanks:
1.Attach clear plastic tube to plastic barb on detergent tank (see Figure 2).
2.Fill detergent tank with detergent formulated for use with pressure washers.
3.Install the black spray tip to apply low pressure detergent.
For Other Units:
1.Attach clear plastic tube to brass barb on pump (see Figure 3).
2.Put the other filter end of the clear tube into the detergent container.
3.Install the black spray tip to apply low pressure detergent.
Why doesn’t the pressure washer apply detergents with high pressure?
The reason you don’t apply detergents with high pressure is that the detergents “bounce” off the cleaning surface as fast as you apply them.
Detergent is only effective when you allow it time to work on the surface of whatever you are cleaning. You can only apply detergent at low pressure, wait
What maintenance do I need to perform on my pressure washer?
1.After turning off the pressure washer and the water, depressurize the hose by triggering the gun.
2.Remove the garden hose and high pressure hose from the pump.
3.Pull the start rope slowly five times to purge water from the pump. This will help protect the pump from damage.
4.DO NOT store your pressure washer in an area where the temperature will drop below 32˚F / 0˚C) unless pressure washer is properly winterized (see Page 15).
Where can I buy accessories for my pressure washer?
• Call your local Husqvarna Dealer.
English — 5
