FUEL HANDLING

Fuelmix

IMPORTANT! The chain saw is equipped with a two-stroke engine and must always been run using a mixture of petrol and two-stroke engine oil. It is important to accurately measure the amount of oil to be mixed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, even small inaccuracies can drastically affect the ratio of the mixture.

!Always provide for good ventilation when handling fuel.

Petrol

Use good quality unleaded or leaded petrol.

The lowest octane recommended is 90.

If you run the engine on a

lower octane grade than 90 so-called, knocking can occur. This gives rise to a high engine temperature, which can result in serious engine damage.

When working with continuous high revs (e.g. delimbing) a higher octane grade is recommended.

Two-stroke oil

For the best results use HUSQVARNA two-stroke oil, which is especially developed for chain saws. Mixing ratio 1:50 (2%).

If HUSQVARNA two-stroke oil is not available, you may use another two-stroke oil of good quality that is intended for air cooled engines. Contact your dealer when selecting an oil.

Mixing ratio 1:33 (3%)-1:25 (4%).

Never use two-stroke oil intended for water cooled outboard motors, so-called, outboard oil.

Never use oil intended for four-stroke engines.

Gasolin

 

Oil • Öl

 

Benzin

 

Huile • Aceite

 

Essence

 

Lit.

 

Gasolina

 

 

2%(1:50) 3%(1:33) 4%(1:25)

Lit.

5

0,10

0,15

0,20

10

0,20

0,30

0,40

15

0,30

0,45

0,60

20

0,40

0,60

0,80

US

 

US

 

gallon

 

fl. oz.

 

 

2%(1:50) 3%(1:33) 4%(1:25)

1

2 1/2

3 3/4

5 1/8

2 1/2

6 1/2

9 3/4

12 7/8

5

12 7/8

19 1/4

25 3/4

26 – English

 

 

 

Mixing

Always mix the petrol and oil in a clean container intended for fuel.

Always start by filling half the amount of the petrol to be used. Then add the entire amount of oil. Mix (shake) the fuel mixture. Add the remaining amount of petrol.

Mix (shake) the fuel mixture thoroughly before filling the saw’s fuel tank.

Do not mix more than max. one month’s supply of fuel.

If the saw is not used for some time the fuel tank should be emptied and cleaned.

Chain oil

The chain lubrication system is automatic. Always use special chain oil with good adhesive characteristics.

In countries where no special chain oil is available, EP 90 transmission oil can be used.

Never use waste oil. This results in damage to the oil pump, the bar and the chain.

It is important to use oil of the right viscosity according to the air temperature.

In temperatures below 0oC (32oF) some oils become too viscous. This can overload the oil pump and result in damage to the oil pump components.

Contact your servicing dealer when choosing chain oil.

Page 26
Image 26
Husqvarna 61, 268 manual Fuel Handling, Fuelmix