OPERATION
SPARK | ENGINE OIL CAP | AUGER |
PLUG | WITH DIPSTICK | CONTROL |
DISCHARGE CHUTE CONTROL LEVER
SAFETY |
|
| LEVER | |
IGNITION |
|
|
| |
KEY |
|
| GASOLINE | |
|
|
| ||
|
|
| FILLER | |
|
|
| CAP | |
CHOKE |
|
| CHUTE | |
|
| DEFLECTOR | ||
CON- |
|
| ||
TROL |
|
|
| |
|
|
| FUEL | |
|
|
| ||
|
|
| VALVE | |
THROTTLE |
|
|
| |
/ ENGINE |
|
|
| |
CONTROL |
|
| DISCHARGE | |
|
|
| ||
|
|
| CHUTE | |
RECOIL | POWER |
|
| |
(AUXILIARY) |
|
| ||
CORD |
|
| ||
STARTER |
|
| ||
PLUG | ELECTRIC |
| ||
HANDLE | OIL DRAIN PLUG | |||
| ||||
|
| START |
| |
|
| BUTTON | ||
PRIMER |
|
|
| |
NOTE: ITEMS ABOVE |
|
| ||
ARE SHOWN IN |
|
|
| |
THEIR TYPICAL |
|
|
| |
LOCATION ON THE |
|
| ||
ENGINE. ACTUAL |
|
|
| |
LOCATION MAY |
|
|
| |
VARY WITH THE |
|
|
| |
ENGINE ON YOUR |
|
|
| |
UNIT. |
|
|
|
DRIVE SPEED CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
LH TURN TRIGGER
DEFLECTOR REMOTE CONTROL LEVER
LIGHT
HANDLE
KNOB
MUFFLER
TOOLBOX
FREEWHEEL CONTROL
DRIFT
CUTTER
AUGERS | FIG. 10 |
|
MEETS A.N.S.I. SAFETY REQUIREMENTS
SKID PLATE
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine. |
| |
Recoil (auxiliary) starter handle - used for starting engine. |
| |
Primer - pumps additional fuel from the carburetor to the |
| |
cylinder for use when starting a cold engine. |
| |
Choke Control - used for starting a cold engine. |
| |
Throttle/engine control - used to select either FAST or |
| |
SLOW engine speed and to STOP the engine. |
| |
LH and RH turn triggers - used to steer the snow thrower. |
| |
(See Fig. 18) |
| |
Freewheel control – disengages transmission for pushing | 9 | |
the snowthrower with the engine off. (See Fig. 21) | ||
|
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Deflector remote control lever - used to change the distance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
Drift cutter - used to cut through deep snowdrifts.