UNASSEMBLED PARTS

Slope Sheet

Key

(1) Oil Drain Tube

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

1/2" wrench

Tire pressure gauge

(2)

7/16" wrenches

Utility knife

 

 

Pliers

ADJUST SEAT (See Fig. 2)

Sit in seat.

Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

Release lever to lock seat in position.

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

Remove all accessible loose parts and parts cartons from carton.

Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

Check for any additional loose parts or cartons and remove.

A

CHECK BATTERY (See Fig. 1)

FIG. 2

• Lift hood to raised position.

NOTE: You may now roll your tractor off the skid. Follow

 

 

 

NOTE: If this battery is put into service after month and year

the appropriate instruction below to remove the tractor

indicated on label (L) (label is located between terminals)

from the skid.

charge battery for minimum of one hour at 6-10 amps.

WARNING: Before starting, read, understand and follow

(See "BATTERY" in Maintenance section of this manual

all instructions in the Operation section of this manual. Be

for charging instructions).

sure tractor is in a well-ventilated area. Be sure the area in

 

 

 

 

 

 

front of tractor is clear of other people and objects.

 

TO ROLL TRACTOR OFF SKID

(See Op-

 

eration section for location and function of

L

controls)

 

 

Raise attachment lift lever to its highest position.

 

Release parking brake by depressing brake pedal.

• Place freewheel control in disengaged position to dis- engage transmission (See “TO TRANSPORT” in the Operation section of this manual).

02931

• Roll tractor forward off skid.

 

5 Continue with the instructions that follow.

FIG. 1

Page 5
Image 5
Husqvarna 532 43 62-68, 96045002201 Unassembled Parts, Tools Required for Assembly, To Remove Tractor from Carton