OPERATION
TO MOVE FORWARD AND BACKWARD (See Fig. 19)
The direction and speed of movement is controlled by the motion control lever. (J)
J
Fig. 19
•Start tractor with motion control lever in neutral position.
•Release parking brake.
•Slowly move motion control lever to desired position.
TO ADJUST GAUGE WHEELS (See Fig. 21)
Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- er position to help prevent scalping in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on a flat level surface.
•Adjustmowertodesiredcuttingheight(See“TOADJUST MOWER CUTTING HEIGHT” in this section of manual).
•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole. Tighten securely.
•Repeat for all, installing gauge wheel in same adjust- ment hole.
TO ADJUST MOWER CUTTING HEIGHT (See Fig. 20)
The position of the attachment lift lever (A) determines the cutting height.
A
Fig. 20
•Put attachment lift lever in desired cutting height slot.
The cutting height range is approximately 1" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.
•The average lawn should be cut to approximately
•For best cutting performance, grass over 6" in height should be mowed twice. Make the first cut relatively high; the second to desired height.
13
Fig. 21
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitat- ing or cutting off when operating your equipment on rough, rolling terrain or hills.
•Select desired height of cut with attachment lift lever.
•Start mower blades by engaging attachment clutch control.
TO STOP MOWER BLADES
•Disengage attachment clutch control.
CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield (S) in place (See Fig. 22).
S
Fig. 22