6. SET UP
English | POSITIONING THE PROJECTOR AND SCREEN |
water, moisture, vibration and strong magnetic fields. | |
| • Place the projector on a stable, level surface, out of direct |
sunlight and away from sources of excessive dust, dirt, heat,
Face the projector towards the screen for the best picture results. To determine the distance for the desired size, please refer to the Projection Assistant, a calculation programme included on the
Video | Video in | L | Audio R | Audio | Power | |
|
|
|
|
| out |
|
Data | Mouse |
| Data in |
| Audioin |
|
3.Press the STANDBY ON/OFF button to switch on the projector.
–The lamp indicator
flashes green and the
– When the projection lamp is on, the lamp indicator lights up green.
–The
switched off before. The factory default position is Power/Standby.
4.To switch off the mains supply completely, pull the mains plug out of the wall socket.
•The screen should be positioned so that it is not directly touched by sunlight or artificial light, as this will wash out the colours of the picture, making it hard to see.
•The projector can be used for both front projection, rear projection and ceiling projection applications. As default factory setting, the projector has been set up for front projection. You can change to rear or ceiling projection via the OSD menu. See ‘Rear screen projection’ and
•Choose a screen size suitable for the number of viewers and the size of the room.
•Picture quality is best when you sit directly in front of the projector screen.
MAINS SUPPLY
1.Insert the mains lead into the projectors POWER socket and connect it to the wall socket.
Note: The standby indicator lights up red, the projector is now in the Power/Standby mode.
2.Remove the lens cap.
Video |
|
|
|
S- |
|
|
|
Videoin | Videoin |
|
|
| L | Audio R | |
|
| ||
Data |
|
| |
|
| Audio | |
Mouse |
|
| Power |
|
| Datain | |
|
|
| in |
|
|
| Audio |
|
|
| out |
Note: Before disconnecting the mains lead, make sure that the
cooling fan has stopped (about 3 minutes after the projector has been switched to Power Standby).
ADJUSTING THE FOCUS AND SIZE OF THE IMAGE
•Use the ZOOM ring to adjust the size of the image.
•Use the FOCUS ring to adjust the focus of the image.
Zoom ring
Focus ring
in | Videoin |
|
|
| L | Audio R | |
|
| ||
|
|
| |
|
|
| Audio |
se |
|
| Power |
|
| Datain | |
|
|
| out |
|
|
| Audio |
|
|
| in |
ADJUSTING THE VERTICAL AND HORIZONTAL ANGLE OF THE PROJECTOR
Vertical angle
•Use the Height/Level Adjuster to adjust the vertical angle of the projector as specified under ‘Positioning the projector and screen’.
To Raise: press the adjuster carefully and lift to raise the projector.
To Lower: press the adjuster carefully again to lower the projector.
•Use the FOCUS Ring and ZOOM Ring to readjust the focus and
size of the image.
8