UNASSEMBLED PARTS
| Mower | Mower Front Wheel | ||
|
| (2) Rear |
|
|
(5) |
| Lift Link | (1) Shoulder Bolt | (1) |
O.D. Washers |
| Assemblies |
| |
|
|
|
| Washer |
(1) Small |
|
|
|
|
Retainer Springs |
|
|
| |
|
| (1) Front |
|
|
|
| Lift Link |
| (1) |
|
| Assembly | (1) Wheel | |
|
| Locknut | ||
(5) Large |
|
|
| |
|
|
|
| |
Retainer Springs |
|
|
| |
| If Equipped | (1) Oil Drain Tube | Slope Sheet | |
|
| |||
|
| (1) 3/4 O.D. | Keys |
|
(1) |
|
| ||
Washers |
|
| ||
|
|
|
| |
| (1) Small Retainer | (2) Keys |
| |
| Springs |
|
| |
|
| ASSEMBLY |
| |
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY | BEFORE REMOVING TRACTOR FROM |
A socket wrench set will make assembly easier. Standard | SKID |
wrench sizes are listed. |
|
(2) | 7/16" wrenches | Utility knife |
(1) | 1/2" wrench | Tire pressure gauge |
(1) | 3/4" wrench | Pliers |
(1) | 3/4" socket w/drive ratchet |
|
(1) 9/16" wrench | Flashlight | |
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TOREMOVETRACTORFROMCARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton .
•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.
•Remove mower and packing materials.
•Check for any additional loose parts or cartons and
remove.5
TO CHECK BATTERY (See Fig. 1)
•Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at
•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.
LABEL |
Fig. 1
