Husqvarna 961430096 TO ASSEMBLE GRASS CATCHER See Fig, INSTALL STARTER ROPE See Fig, Assembly

ASSEMBLY

BOLT

KNOB

HANDLE

BRACKET

FIG. 2

TO ASSEMBLE GRASS CATCHER (See Fig. 3)

1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.

2.Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.

FRAME

HANDLE

VINYL	FRAME
BINDINGS	OPENING

FIG. 3

INSTALL STARTER ROPE (See Fig. 4)

1.Loosen T-knob.

2.Hold control bar against upper handle.

3.Slowly pull engine starter rope out until rope will slip into loop of rope guide.

4.	Tighten T-knob.
		CONTROL BAR
		UPPER
		HANDLE
	ROPE GUIDE	T-KNOB
		ENGINE
		STARTER
		ROPE
		FIG. 4

TO INSTALL ATTACHMENTS

Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see “TO CONVERT MOWER” in the Operation section of this manual.

5