Husqvarna 966043502, 70 LP owner manual Assembly

ASSEMBLY

RH. Handle

Brace

1/4-20 x 2 1/4”

Hex Bolt

1. Remove components from carton and place spreader upside down on a padded surface. Install LH. & RH. handle braces to frame as shown using four (4) 1/4-20 x 2 1/4” hex bolts and nuts but do not tighten.

3/16 Dia x 2”

Cotter Pin

Drive Wheel

1/8 Dia x 1 1/4”

Cotter Pin

1/4-20

Hex Nut

LH. Handle

Brace

2. Slide wheels onto end of axle with the hub facing toward frame. Wheels are identical to ease assembly. Align the hole in the wheel hub and the hole in the axle as shown. Secure drive wheel to axle with 3/16 dia. x 2” cotter pin. Insert 1/8 dia. x 1 1/4” cotter pin in the hole near the end of axle to retain free turning wheel.

Free Turning

Wheel

3. Turn spreader upright. For ease of assembly, make sure ON/OFF cable is on top of handle braces. With DOT on the handle assembly facing as shown, secure clamp bracket using a #10 x 3/4 slotted sheet metal screw. Install end of handle assembly between handle braces and secure with (2) 1/4-20 x 1 1/2” hex bolts and nuts.

2

#10 x 3/4	Clamp
Sheet Metal	Bracket	DOT
Screw

Handle

Assembly

1/4-20

Hex Nut

1/4-20 x 1 1/2”

ON/OFF Cable Hex Bolt