Handle Grip
ON/OFF Control
#10 x 3/4”
Sheet Metal Screws
4. Attach ON/OFF control to the upper handle using (2) #10 x 3/4” slotted sheet metal screws. Slide handle grips onto the handle cross tube. Soapy water will ease installation. (Do not use petroleum based products).
| | | | Clamp |
| ON/OFF Cable |
| | Bracket |
| | | |
| | | | |
| | | |
| Clamp | | | |
| | | | |
5. Secure On/Off cable to the clamp bracket using the cable clamp and #10-24 x 5/8” screw and locknut as shown but do not tighten. Place On/ Off control in the “ON” position and set the rate retting dial to the “WASH” position. Pull cable away from hopper sliding it in the cable clamp until the shut off plate stops against the rate setting dial. Tighten cable clamp securely. To check spreader for complete shutoff, pull the On/Off control lever back to the “OFF” position. Check to make sure hole in the hopper is completely closed. If not, loosen the cable clamp and slide the cable forward until the hole in hopper is closed. Re-tighten bolt and check shutoff.
#10-24 x 5/8”
Screw & Locknut
ON
| | Rate Setting |
Shut Off | |
| Dial |
Plate | |
| | |
| | | |
| | | |
| | | |
Screen
Screen Clips
6. Insert screen into hopper by sliding it under the screen clips.
3
