U.S |
| Imperial |
| Metric | |
|
|
|
|
|
|
Gas | Oil | Gas | Oil | Gas | Oil |
Gal. | Oz. | Gal. | Oz. | Gal. | Oz. |
|
|
|
|
|
|
1 | 5 | 1 | 6 | 4 | 166 |
2 | 10 | 2 | 12 | 8 | 322 |
To start engine, place the unit in a flat, clear area.
Move the On/Off Switch to the 'I" position.
ON/OFF SWITCH
ON/OFF
SWITCH
Fig. 5
WARNING: If you are unable to start this engine after following instructions in this manual, contact your Authorized Tecumseh Servicing Dealer. To avoid serious burn injuries or damage to your engine, DO NOT attempt to start or troubleshoot this engine in any other way. For example:
•DO NOT use starting fluid.
•DO NOT spray flammable liquids into carburetor or onto air cleaner.
•DO NOT put flammable liquids into carburetor or onto air cleaner.
•DO NOT operate engine or pull on starter rope with spark plug removed. Fuel can spray from spark plug hole and ignite.
1.To avoid carbon monoxide poisoning, make sure engine is outdoors in a well
2.Move rocker switch to "I" position.
3.Move choke control lever to "Full Choke" Position (see equipment manufacturer's instructions). See Fig. 7
Note:
If restarting a warm engine after a short shutdown, move choke lever to "NO CHOKE" position.
CAUTION: DO NOT start engine without pushing in yellow compression relief valve FIRST. Failure to do so may result in bruised fingers and accidental equipment movement which could result in minor or moderate injury.
4. Push yellow compression relief valve in. See Fig. 8.
Note:
Yellow compression relief valve will "pop" outward once engine starts.
Fig. 6 Typical Engine Choke Symbol
2
1.Switch in "ON" Position
2.Full Choke Position
Fig. 7 Switch and Full Choke Positions
Fig. 8 Yellow Compression Relief Valve
7
