THROTTLE CABLE
Unwind throttle cable from around engine. CAUTION: Be careful not to kink cable.
ON/OFF SWITCH
1.Place 1 3/8” long slotted pan head screw into switch plate and down through hole in upper right hand handlebar. (See Fig. 2)
2.Place rubber isolator over screw underneath handlebar. Follow with throttle trigger body.
3.Place flat nut though slot in side of throttle trigger and tighten screw to secure throttle control to handlebar.
KILL WIRE
CONNECTION AT | CONNECTION |
SWITCH END | AT ENGINE END |
Fig. 2
4.Push 2 terminals of kill wire (See Fig. 3) onto 2 prongs of shut off switch.
5.Push other end of kill wire onto engine.
SCREW
SWITCH
HANDLEBAR
RUBBER
ISOLATOR
THROTTLE
CONTROL
FLAT NUT
Fig. 3
6.Retain kill wire and throttle cable to right handle bar using two (2) nylon tie straps. Cut off loose ends of the straps. (See Fig. 4)
GRIPS
TIE STRAPS
Fig. 4
7.Install grips.
8.Tine spacers provided can be placed in toolbox or garage shelf (see page 9).
8. Fuel mix cup is provided for your convenience.
THIS COMPLETES THE ASSEMBLY OF YOUR UNIT.
As with any item of power equipment, it is necessary that you learn and observe ALL Safety precautions. This includes care of the machine as well as personal safety.
DO NOT BE CARELESS!
Read the operating instruction manual carefully. Be thor- oughly familiar with the controls and proper use of the equipment.
Always wear goggles or face shield for eye protection. It is advisable to wear protective head gear. These precautions are used to prevent the possibility of being struck by objects thrown from the rotating tines.
It is advisable to wear a long sleeve shirt or jacket. Don’t wear shorts. Don’t wear loose clothing or jewelry.
Do not operate this unit when barefoot or wearing open sandals. Always wear substantial footwear; leather work shoes or short boots function well for most people. Either will help protect the operator’s ankles and shins from objects being thrown by rotating tines.
DANGER!
DO NOT SMOKE while filling the tank, or starting the engine. Be sure the proper fuel is used. Read the fuel instructions in the manual and/or on the engine. Always store the fuel to be used in this machine in a properly marked container that is approved for such use.
STARTING INSTRUCTIONS
Be sure you are using the proper fuel and have read and under stand all the instructions on the preceding pages.
6