Hydro Intermediate Walk Behind

Adjustment Instructions for:

MODELS / I.D. : 968999105 968999111 968999106

/

/

/

WH3614A

WH3615A

WH4817A

CUTTING HEIGHT

1.Before changing cutting heights make sure the blades are off, key switch is off, and remove spark plug wire or wires.

2.Cutting height ranges from 1 1/2” to 5” in 1/4” increments.

3.Cutting height can be changed three ways. Move one “C” spacer on the front casters, change the blade spacers, or move the wheel motor assemblies.

4.a. To change heights on the rear deck loosen, do not remove, the top two carriage bolts on both sides. (see fig. 1a)

b.Place a jack under the center of the rear deck remove the bottom two nuts on both sides. Then remove the bottom two bolts both sides. (May have to raise the jack slightly to remove bolts.)(see fig. 1b)

c.With the jack raise or lower the rear deck to the desired position using the chart, on page 7, to ensure proper height.

16

Page 16
Image 16
Husqvarna 968999102 / W3612A, 968999110 / W4815A, 968999107 / W3213A manual Hydro Intermediate Walk Behind, Cutting Height