Husqvarna 968999250, Z4818BIA manual Assembly

ASSEMBLY

TO ROLL THE MOWER OFF OF THE SKID (See Operation section for location and function of controls

•Move to the rear of the mower, and place the IZT (Integraded Zeroturn Transaxle) bypass linkages into the bypass position to disengage the IZT’s (See “TO TRANSPORT” in the Operation section of this manual).

•Sitting on the mower, press the deck lift pedal in to the highest cutting position.

•Release park brake lever.

•Roll the mower forward or backward off of the skid.

TO DRIVE THE MOWER OFF OF THE SKID (See Operation section for location and function of controls)

WARNING

Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure the mower is in a well-ventilated area. Be sure the area in front of the mower is clear of other people and objects.

•Be sure all of the above assembly steps have been completed.

•Check engine oil level and fill fuel tank with gasoline.

•Place the IZT(Integraded Zeroturn Transaxle) bypass linkages into the drive position (See “TRANSPORT” in the Operation section of this manual).

•Sit on the seat in the operating position, set the park brake lever to the on position.

•Rotate the control levers outward into the neutral slot.

•Press forward on the deck lift pedal to raise the deck into the highest cutting position.

•Place the throttle control into the choke position.

•Start the engine. After the engine has started, move the throttle control to the idle position.

•Release the park brake.

•Move the control levers into the operate position.

14