Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna 968999250, Z4818BIA To Start AN Engine with a Weak Battery, To Attach Jumper Cables

Models: 968999250 Z4818BIA

1 52

Download 52 pages 1.12 Kb

Page 42

SERVICE AND ADJUSTMENT

TO START AN ENGINE WITH A

WEAK BATTERY

WARNING

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See “BATTERY” in the Customer Responsibilities section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR MOWER IS EQUIPPED

WITH A 12-VOLT NEGATIVE GROUNDED

SYSTEM. THE OTHER VEHICLE MUST ALSO

BE A 12-VOLT NEGATIVE GROUNDED

SYSTEM. DO NOT USE YOUR MOWER

BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES

•Connect each end of the RED cable to the POSITIVE (+) terminal on each battery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

•Connect the other end of the BLACK cable to a good CHASSIS GROUND, away from the fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

Image 42

Husqvarna 968999250, Z4818BIA manual To Start AN Engine with a Weak Battery, To Attach Jumper Cables

Contents

Operators Manual Models 968999250 / Z4818BIAGood Service Contents Symbols and Decals Safety Instructions Safety InstructionsGeneral Use Personal protective equipment Driving on Slopes Do as followsChildren 8011-563 Transport Machine. Activate the parking brake, turn offSpecifications Customer ResponsibilitiesTo Remove the Mower From Crate AssemblyTools Required For Assembly Unpack CrateBefore Removing Mower from the Skid Attach Seat See FigAttach Control Levers See Fig Assembly Checklist Check the Tire PressureOperation ControlsIZT Integraded Zeroturn TransaxleBYPASS Linkages Deck Blades HOW to USE Your MowerTo SET Parking Brake See Fig EngineTo USE Throttle Control See Fig To USE Choke Control See FigTo Move Forward and Backward See Fig CZ-7 To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See FigureTo Operate Mower To Operate on HillsTo Transport See Fig Before Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See Fig Mowing Tips Maintenance Schedule General Recommendations Before Each USELubrication Chart Tires Operator Presence SystemBlade Care Blade Removal See FigTo Sharpen Blade See Fig Battery BeltsEngine LubricationAIR Filter Clean AIR ScreenClean AIR INTAKE/COOLING Areas Engine OIL FilterCleaning IN-LINE Fuel Filter See FigsService and Adjustment MowerTo Level Deck FRONT-TO-BACKADJUSTMENTSee Fig To Replace Deck Belt To Adjust the Seat See Fig To Replace IZT Integraded Zeroturn Transaxle Belt See FigTo Adjust Control Levers See Fig To Remove Wheels for RepairTo Start AN Engine with a Weak Battery To Attach Jumper CablesReplacing Battery See Fig To Adjust Park Brake Tracking AdjustmentBattery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Wiring Schematic