ASSEMBLY
4 | SUPPORT POST (See Fig. 4) |
Use Hardware - - GROUP "C" | |
| CAUTION: Container support is spring |
| loaded and locked to the cover. Handle |
| cover assembly carefully so as not to |
| unlatch the cover from the container |
| support. |
|
|
•Rotate cover assembly onto its side as shown.
•Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely.
CARRIAGE
BOLTS
SUPPORT
POST
LOCKNUTS
FIG. 4
5 | MOUNTING TO TRACTOR (See Fig. 5) |
Use Hardware - - GROUP "D" |
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor.
BRACKET SUPPORT PIN
END CAP
SUPPORT POST
LANCED TABS
MOUNTING
BRACKET
COVER ASSEMBLY
RETAINER
SPRING
FIG. 5
•Raise seat on tractor to allow assembly to be mounted.
•With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket.
•Line up holes in mounting bracket with holes in support post and insert bracket support pin. Secure with retainer spring.
•Unlatch and open cover.
•Install the three (3) tubing end caps onto container support.
•Tap each end cap onto container support tubes to seat securely.
6 | CONTAINER ASSEMBLY (See Fig. 6) |
No hardware required |
•Place bottom half inside of top half, as shown.
•Place one foot inside bottom half and lift top half to meet bottom half.
•Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN INSET.
•Repeat for second container.
8
