ASSEMBLY
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM HALF
PRESS TOGETHER TO FORM
SEAL WHILE LIFTING TOP HALF LOCKING TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
WAR | NING |
|
8 | LOWER CHUTE (See Fig. 8) |
Use Hardware - - GROUP "E" |
•Raise and hold deflector shield in upright position.
•Slide back edge of chute over rear corner of mower deck and pivot forward.
•Align slot in lower chute with hex bolt in mower deck baffle and close chute over deck openning.
•Secure with washer and wing nut.
CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation.
DEFLECTOR SHIELD
WASHER
MOWER DECK
BAFFLE
FIG. 6
7 CONTAINER MOUNTING (See Fig. 7)
No hardware required
•Install one container to left side first with warning to outside of unit. Install other container to right side.
NOTE: Right container should always overlap left container at center support.
•Close cover and lock latch handle over center support tube.
COVER LATCH
HANDLE
CONTAINER
WARNING
GN NI | R AW |
ARNING
CONTAINER
HANDLE
CENTER
SUPPORT
TUBE
WING NUT | HEX BOLT |
| |
| FIG. 8 |
9 CHUTE LATCH ASSEMBLY
(See Fig. 9)
Use Hardware - - GROUPS "F & G"
•Assemble latch pin to upper chute, as shown.
•Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown.
•Tighten all hardware securely.
| WASHERS |
#10 x | 3/16 x 3/4 x 16 Ga. |
SPLIT
SPACER
ACORN NUT
UPPER CHUTE | RUBBER |
LATCH |
WELD
#10 x 5/8"NUT SCREW
LOWER CHUTE
WASHER
LOCK WASHER
CONTAINER WARNING
3/16 x 3/4 x 16 Ga.
FIG. 7 | 9 | FIG. 9 |
|