Husqvarna CZE 4818 To Adjust Anti-Scalp Roll, ERS See Figure, Operation, To Operate On Hills

OPERATION
FOOT		ANTI-SCALP
		ROLLER
PEDAL
LIFT
ARM
HEIGHT
PLATE
CZ-8	FIGURE 6	CZ-9
FIGURE 5

TO ADJUST ANTI-SCALP ROLL-	TO OPERATE MOWER
	Your mower is equipped with an operator
ERS (See Figure 6)
	presence system. When the engine is running,
Anti-scalp rollers are properly adjusted when	any attempt by the operator to leave the seat
	without first setting the park brake will shut off
they are just slightly off of the ground when the	the engine.
deck is at the desired cutting height in the	• Select desired height of cut.
operating position. Anti-scalp rollers then keep
	• Start deck blades by pulling the PTO
the deck in the proper position to help prevent
	switch up into the engaged position.
scalping in most terrain conditions.
	• To stop the deck blades, press down on
NOTE: Adjust Anti-scalp rollers with the mower	the PTO Switch into the disengaged
	position.
on a flat level surface.

•Adjust the deck to the desired cutting height (see “TO ADJUST DECK CUT- TING HEIGHT” in the operation section of this manual).

•Using a 3/4" wrench and a 9/16" wrench, remove the nut and shoulder bolt from the anti-scalp roller.

•Lower the anti-scalp roller to the ground, and raise it up to the next highest hole.

•Replace and tighten the nut and shoulder bolt.

•Be sure to adjust all of the anti-scalp rollers to the same position.

•Be sure to readjust the anti-scalp rollers if the cutting height is changed.

WARNING

Do not operate the deck without either the entire grass catcher, mulch kit or discharge chute installed.

TO OPERATE ON HILLS

WARNING

Do not drive up or down hills with slopes greater than 10 degrees. And do not drive across any slopes.

IMPORTANT: THE ANTI-SCALP ROLLERS MUST NOT BE USED FOR GAUGE WHEELS OR THE ROLLER AND DECK MAY BE DAMAGED.

18