` 5

Non-Pump Model

1In case that it goes over a door sill.

Don’t let the height of the drain hose exceed 20cm from the bottom of washer.

20Cm

2In case of extending the drain hose.

Don’t let the total length exceed 3m.

3m

3Be careful that the end of the drain hose is not immersed in water.

Pump Model

Laundry tub drain system

Standpipe drain system

Top of tub must be at least 86cm

Needs a 3cm minimum diameter

(34inches) high and no higher than 130cm

standpipe with minimum carry away

from bottom of washer (A)

capacity of 30liters per minute.

 

Top of tub must be at least 86cm

 

(34inches) high and no higher than 130cm

 

from bottom of washer (B)

A

 

 

B

ELECTRICAL REQUIREMENTS

WARNING

electrical shock hazard: failure to follow these instructions could result in death or serious injury.

Electrical earth is required on this washer

If it does not fit the outlet, have a proper outlet installed by a qualified electrician.

Don’t earth to a gas pipe

Don’t change the power supply cord plug.

Check with a qualified electrician if you are not sure the washer is properly earthed.

Recommended earthing method

C

B

A

For your personal safety, this washer must be earthed.

This washer is equipped with a power supply cord (A) having a earthing plug (B). To minimize possible shock hazard, the cord must be plugged into a mating earthing-type wall receptacle (C).

If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have the proper earthed wall receptacle installed by a qualified electrician.

5

Page 5
Image 5
Husqvarna DWF-7589, DWF-8089 instruction manual Electrical Requirements, Non-Pump Model