8
THE FUNCTIONS OF THE CONTROL PANEL
START
HOLD
POWER
WATER
LEVEL COURSE RES. PROCESS
WASH
TEMP.
HIGH
COLD MEDIUM
LOW
SMALL
HOT
WASH TEMP. DETERGENT
FUZZY REMAIN RINSE
SPRAY RINSE
SPINWASH
RES.
MIN.
BLANKET
ECONOMY
SUIT
SOAK
CONTROL
ONLY SPIN
• Press this switch to turn the power on or off.
• It can be used to choose water temperature to be supplied.
• As the button is pressed, water temperature will be repeated.
COLD ➝COLD+HOT ➝HOT
• In case of the single valve model, there is no wash temperature
selector function.
• It can be used to adjust amount of water according to the size of the
load to be washed.
• As the button is pressed, water level is selected by
MEDIUM ➝ HIGH ➝ SMALL ➝ LOW
• It can be used to pre-engage time for wash.
• It is the button for the partial process or the combination of each
process (wash, rinse, spin) (See page 10)
• If you want to change wash time, rinse times, spin time, you must
press this button after selecting each process by the process button.
Also, this button can be used to spin only. (See page 10)
• It can be used to select the full-automatic course.
• As the button is pressed, course will be selected by following order:
FUZZY ➝BLANKET ➝ECONOMY ➝SUIT(WOOL) ➝SOAK
• Operation and temporary stop is repeated as it is pressed.
• When you want to change course in operating;
press the "START/HOLD" button➝Select the course that you want to
change ➝press the "START/HOLD" button again.
POWER
WATER
LEVEL
RES
PROCESS
CONTROL
ONLY SPIN
COURSE
START/
HOLD
WASH
TEMP.
`8