Husqvarna GT48XLSi Unassembled Parts, Tools Required For Assembly, Toremovetractorfromcarton

Models: GT48XLSi

1 72
Download 72 pages 20.35 Kb
Page 5
Image 5
UNASSEMBLED PARTS

UNASSEMBLED PARTS

Slope Sheet

(1) Oil Drain Tube

(1) Quick Connect

*Installed by Dealer

*Brush Guard Kit

*Pedal

(2) Screw

(2) Nut

 

U-Channel

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1)

1/2" wrench

Tire pressure gauge

 

(2)

7/16" wrenches

Utility knife

Pliers

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TOREMOVETRACTORFROMCARTON

UNPACK CARTON

Remove all accessible loose parts and parts cartons from carton.

Remove end panels and lay side panels flat.

Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

ADJUST SEAT (See Fig. 2)

Sit in seat.

Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

Release lever to lock seat in position.

A

Fig. 2

NOTE: You may now roll your tractor off the skid. Continue using the instructions that follow to remove the tractor from the skid.

TO CHECK BATTERY (See Fig. 1)

Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.

LABEL

Fig.ASSEMBLY1

TOOLS REQUIRED FOR ASSEMBLYWARNING: Before starting, read, understand and fol- low all instructions in the Operation section of this manual. Ensure tractor is in a well-ventilated area. Ensure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

Raise attachment lift lever to its highest position.

Release parking brake by depressing brake pedal.

Place freewheel control in disengaged position to disengage transmission (See “TO TRANSPORT” in the Operation section of this manual).

Roll tractor forward off skid.

Continue with the instructions that follow.

5

Page 5
Image 5
Husqvarna GT48XLSi Unassembled Parts, Tools Required For Assembly, Toremovetractorfromcarton, Unpack Carton, Fig