SERVICE AND ADJUSTMENTS
WASHERS
RETAINING
RING
AXLE COVER
FIG. 36
TO START ENGINE WITH A WEAK BATTERY (See Fig. 37A)
CAUTION:
If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the CUSTOMER RESPON- SIBILITIES section of this manual).
If “jumper cables” are used for emergency starting, follow this procedure:
REPLACING BATTERY (See Fig. 37B)
CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,rings,etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
•Lift hood to raised position.
•Remove terminal guard.
•Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
•Install new battery with terminals in same position as old battery.
•Reinstall terminal guard.
•First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
•Connect BLACK grounding cable to negative
•Close terminal access doors.
•Close hood.
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to the POSITIVE (+) |
terminal of each battery, taking care not to short against |
chassis. |
• Connect one end of the BLACK cable to the NEGATIVE |
• Connect the other end of the BLACK cable to good |
KEPS NUT
TERMINAL
ACCESS
DOOR
TERMINAL
GUARD
HEX
BOLT
POSITIVE (RED)
CABLE
NEGATIVE (BLACK)
CABLE
CHASSIS GROUND, away from fuel tank and battery. |
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries.
“POSITIVE” | “NEGATIVE” | |
(+) | ||
| ||
| L.H. PANEL | |
| BOLT |
FIG. 37A
FIG. 37B
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp
TO ADJUST ATTACHMENT LIFT SPRING (See Fig. 38)
•While holding spring bushing with wrench, loosen jam nut.
26